Double Layer Gunbelts
Your belt is the foundation on which your concealment system is built on. It's been said that a bad belt will make even the finest holster uncomfortable, and conceal poorly. I agree.
My lined Gunbelts are made of double layer 6/7 oz premium cowhide, and are available in 1-1/4" and 1-1/2" widths.
You have the option of ordering single or double stitching, with Brass or Nickel Plated buckles.
The buckles are attached with chicago screws (brass screws for brass buckles, and nickle screws for nickel buckles), so you can always change out the buckle in the future. I
f you have any questions regarding sizing, please e-mail me.
When ordering a belt, it is imperative that you follow the directions for Belt Sizing at the bottom of the page.
I cannot accept returns on belts due to a mistake in sizing on your part
Buckle Colors:
All buckles are available in Brass or Nickle colors
Buckle Styles:
1-1/2" Belt Buckles
1-1/4" Belt Buckles
#OGL-SS- Single Stitch Gunbelt
(shown in Cordovan)
Price- $80.00
#OGL-DS- Double Stitch Gunbelt
(shown in Cordovan)
Price- $85.00
Belt Sizing
Lay your old belt flat on a table or floor and measure from the inside edge of the tip of the buckle (A) to the center of the hole that you wear your belt (B).
Remember to keep in mind the Inside the Waistband holster or IWB accessories (if applicable) that you will be wearing on your belt and add length as needed. Typically, two inches of extra length will be enough to accomodate an IWB holster, but that is not always true for every individual.
The most accurate method, is to put on your old belt with all your gear in place. Take note of which belt hole you used and measure to that belt hole. If you currently don't yet have an IWB holster or accessories, you can take your
UN-LOADED gun (
check it twice, check it again, move all ammo to a different room), magazine, etc. and tuck it into your pants in the position you will be carrying. Once again, if you have ANY doubt about your measurements please e-mail me and we can get it worked out.